Door Frames
It would be helpful to be able to adjust the width of the top frame (header) different than the frame width at the sides (jambs). it is common for doors installed in CMU block walls to have a 4″ with at the frame header to course out with the CMU block coursing of 7′-4″ and…
Read Moretilt-and-turn window
Extends the options at the hopper window to a tilt-and-turn window.
Read MoreGarage Doors
Overhead garage doors with 2D graphic of opening. Ability to change number of panels and vertical/horizontal & left/right window configurations within the panels
Read MoreComponents utilize current() DC Sketchup Function for width and height
It would be nice if the FlexTool components used the CURRENT DC formula for width and height for situations when you are replacing an existing component with a FlexTools component. That would save a lot of time if you are replacing all the windows or doors in a project that has other window/door components that…
Read More(slightly) Complex windows
Maybe a bit too much to ask… Would a window like this be possible oneday ? They aint designer but they are popular in the UK at the lower end of the market
Read MoreSliding Barn Doors
Adding a barn style sliding door tool.
Read MoreDifferent materials for inside and outside of window frame/casement
Hi, I use FlexTools windows a lot in my design but spend quite a bit of time modifying the default frame components to allow the use of different materials on the inside and outside of the frame. Most window manufacturer offer different finish options for their frames, for example anodised aluminium on the outside and…
Read MoreWallCutter Layer Templates
In wall cutter–a refinement of the software for interior elevations would be to set the last cutting plane range to change the reveal. So the first first layer of say for instance 8 layers could be the full frame range and the last could be a smaller range. Basically, you could make a template for…
Read Morefile2compfinder
Открывать в component finder не только директории, но и отдельные файлы, если это возможно. Было бы очень удобно извлекать компоненты из ранее сделанных проектов. С уважением, Сергей. Open in component finder not only directories, but also individual files if possible. It would be very convenient to extract components from previously made projects. Respectfully, Sergey.
Read MoreWall Cutter 2 – Cut all components in one shot
Would like to see wall cutter can cut 2 or more components at the same time. Example from attached image, the door (wall cutter) can be placed and auto cut hole on 1. Glass panel 2. Window frame both in same time.
Read More